Kawi2strokes.com Forum
http://kawi2strokes.com/forum/

S3 carb tuning kits soon to be in production
http://kawi2strokes.com/forum/viewtopic.php?f=25&t=4237		 Page 1 of 1
Author:  Ivan [ Sat Aug 25, 2012 3:37 pm ]
Post subject:  S3 carb tuning kits soon to be in production
http://www.ivansperformanceproducts.com/s3.htm

The initial kits will be for the S3 & S3A... (2.0 slides) and O-2 needle jets....

Later I will get to the KH400 (2.5 slides) and O-6 needle jets.

The kit will contain my usual polished stainless multi taper needles that are in my H1 & H2 kits and also new needle jets, and the assortment of mains and pilots... not sure about the pricing yet because I don't know how many of each size that I'm going to include.

I got a nice improvement so far in response and torque when leaving a stop, midrange power as well as more top end power... very smooth engine....

Me likey !! :thumbup:

Ivan :)
Author:  scouse [ Sat Aug 25, 2012 4:30 pm ]
Post subject:  Re: S3 carb tuning kits soon to be in production
cool

Gary T
Author:  kawi3cyl [ Sat Aug 25, 2012 5:01 pm ]
Post subject:  Re: S3 carb tuning kits soon to be in production
Ivan wrote:
The initial kits will be for the S3 & S3A... (2.0 slides)

I'm hoping this kit will work good when using S3 carbs on an S2, as many here perform this upgrade... :think:
Author:  Tim Steele [ Sat Aug 25, 2012 5:54 pm ]
Post subject:  Re: S3 carb tuning kits soon to be in production
Let me know how they work on a S2 motor with S3 carbs...I may have to get a set too.
Author:  ThreePipesSmokin [ Mon Aug 27, 2012 5:31 am ]
Post subject:  Re: S3 carb tuning kits soon to be in production
According to the resource site, S2 brass is the same as S3 with the exception of the pilot jet. Should work fine on my S1 with S2 carbs! :thumbup:
Author:  Ivan [ Thu Nov 22, 2012 9:06 am ]
Post subject:  Re: S3 carb tuning kits soon to be in production
S3 & S3A kits are ready finally....
www.ivansperformanceproducts.com/s3.htm

They are the same price as my H1 500 kit and contain all the same combination of components specifically spec'ed out for the S3.
More power everywhere, much better fuel mileage, more torque leaving a traffic light.

Main jets (6 sizes)
Pilot jets (2 sizes)
Needles (my own design, mirror finished, 5 angle stainless steel)
Needle jets (Exact duplicates of the originals)
Stainless allen bowl screws
An easy setup sheet and installation tips

Holiday sale prices will be honored for this new product from me.

Happy Holidays to everyone !! :thumbup:

Ivan
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/