Kawi2strokes.com Forum
http://kawi2strokes.com/forum/

1971 Kawasaki H1A Coil
http://kawi2strokes.com/forum/viewtopic.php?f=2&t=15060		 Page 1 of 1
Author:  Hillclimber [ Sun Sep 08, 2024 10:36 am ]
Post subject:  1971 Kawasaki H1A Coil
Hello:

On the old coil when you look down the area where you screw the cap on to hold the wire into the coil, you can see a small metal pin looking up at you. This is where the end of the wire pushes the metal pin into the wire thus allowing current to flow.

I purchased a NOS coil off E Bay. When I look into the area where the wire goes into the coil, I do not see the metal pin which is to go into the wire.

Is there another way the wire going into the coil can be secured to make contact in order for it to work or is this coil no good?

Thank you
Author:  0120raptor [ Sun Sep 08, 2024 11:28 am ]
Post subject:  Re: 1971 Kawasaki H1A Coil
Gary
I have the correct coil for you. If I`d known earlier I could have slipped it in with the 2 "B" packs I sent.
I`ve changed to Zeeltronic on my H1A so no longer need it. Interested ?
Neil
Author:  Jim [ Sun Sep 08, 2024 11:48 am ]
Post subject:  Re: 1971 Kawasaki H1A Coil
Hillclimber wrote:
When I look into the area where the wire goes into the coil, I do not see the metal pin which is to go into the wire.

Is there another way the wire going into the coil can be secured to make contact in order for it to work or is this coil no good?


Someone broke off the little spike. I might work that way for a while, with arcing between the wire and what's left of the spike, but it's not what you want for the long term.
Author:  Hillclimber [ Sun Sep 08, 2024 2:35 pm ]
Post subject:  Re: 1971 Kawasaki H1A Coil
Thank you for the offer Neil. Fortunately I have a 2nd NOS coil that does have the spike in it.

I guess the other one with out the spike is garbage.

Thank you to who replied.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/