Anyone know who's bike this is? I would like to ask them a couple of questions about it.
| Kawi2strokes.com Forum http://kawi2strokes.com/forum/ |
|
| Anyone know this bike? http://kawi2strokes.com/forum/viewtopic.php?f=2&t=1439 |
Page 1 of 1 |
| Author: | oxford [ Sun Oct 23, 2011 9:06 pm ] |
| Post subject: | Anyone know this bike? |
Anyone know who's bike this is? I would like to ask them a couple of questions about it.
|
|
| Author: | rotortech [ Mon Oct 24, 2011 4:36 am ] |
| Post subject: | Re: Anyone know this bike? |
Yeah, like where did the front brakes come from??? Nice. |
|
| Author: | Ric [ Mon Oct 24, 2011 7:59 am ] |
| Post subject: | Re: Anyone know this bike? |
Ha ! Look who's in the picture.... |
|
| Author: | Ja-Moo [ Mon Oct 24, 2011 11:43 am ] |
| Post subject: | Re: Anyone know this bike? |
Ric wrote: Ha ! Look who's in the picture.... Grizzly Adams?........ 
|
|
| Author: | Walms [ Mon Oct 24, 2011 11:49 am ] |
| Post subject: | Re: Anyone know this bike? |
Ric wrote: Ha ! Look who's in the picture.... I'll bite... The owner of the bike? Still, 1 equation, 2 unknowns...
|
|
| Author: | Bobo [ Mon Oct 24, 2011 2:37 pm ] |
| Post subject: | Re: Anyone know this bike? |
Tokico calipers from what I can see.... |
|
| Author: | Ja-Moo [ Mon Oct 24, 2011 2:54 pm ] |
| Post subject: | Re: Anyone know this bike? |
Those are not cut stock rotors...... |
|
| Author: | usernameandpassword [ Mon Oct 24, 2011 3:04 pm ] |
| Post subject: | Re: Anyone know this bike? |
I like the 69/70 DT1 in the background. Looks like a nice complete bike except missing the mirror. Nice! |
|
| Author: | oxford [ Mon Oct 24, 2011 4:56 pm ] |
| Post subject: | Re: Anyone know this bike? |
From some sifting through brake rotors on Ebay, I figured out that the rotors on the bike are from a cbr f4i. I don't know yet if the bolt pattern and the center hole is the same, or if some machine work was done. It does appear to be a stock H series hub. I'll take a guess on the calipers and say that they were from a pre radial brake gsxr 600 or 750. The caliper adapters look like some very nice cnc jobs. I would still like to know how much machine work was needed to get this to all work. If you look closely at the hub there looks like there are somekind of machine marks on the edge where the rotor sits(inbetween every mounting bolt). |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|