| Kawi2strokes.com Forum http://kawi2strokes.com/forum/ |
|
| Rear Shock specifications http://kawi2strokes.com/forum/viewtopic.php?f=2&t=13395 |
Page 1 of 1 |
| Author: | keithwwalker [ Tue May 01, 2018 4:23 am ] |
| Post subject: | Rear Shock specifications |
Looking for 1975 H2C rear shock specifications: Length 325mm Stroke length ? Swingarm Pivot to Ground height (with bike level & unloaded) ? Bike Weight Over Front Wheel (unladen) ? Bike Weight Over Rear Wheel (unladen) ? Maximum Wheel Travel Allowed (to keep swingarm from impacting frame) ? My bike is in parts so I can't pull these numbers right now. Any help is appreciated. Remember, 1974 and before have shorter swingarm so not helpful Thanks kww |
|
| Author: | keithwwalker [ Sat May 05, 2018 8:13 am ] |
| Post subject: | Re: Rear Shock specifications |
Here are my dimensions that I measured in millimeters. This for my 1975 H2C A 315 Rear Axle to Ground (bike level) B 370 Swingarm Pivot to Ground (bike level) C 600 Swingarm Pivot to Upper Shock Mount D 325 Extended Shock Length (fully extended) E 248 Collapsed Shock Length (fully collapsed, no bump stop, must have tyre to mudguard/frame clearance). F 510 Swingarm Pivot to Lower Shock Mount G 530 Swingarm Length (swingarm pivot to axle in middle position) H 40 Lower Shock Mount to Swingarm Centreline (perpendicular to swingarm axis) I 14 Upper Eyelet Bolt Diameter J 20 Uper Eyelet Width K 10 Lower Eyelet / Bearing Bolt Diameter L 20 Lower Eyelet / Bearing Width M 92 Maximum Wheel Travel Allowed N 111.8 Bike Weight Over Front Wheel (unladen) KG O 270.6 Bike Weight Over Rear Wheel (unladen) KG P 154.6 Bike Weight Over Front Wheel (laden) Q 370.4 Bike Weight Over Rear Wheel (laden - rider should adopt riding position applicable to the intended use of the bike) The weights are in KG and assume weight distribution of 40% front/60% rear (unladen and full tank) and 30% front/70% rear of rider weight. Shock travel is about 3" assumed. If anyone has any corrections, please let me know, appreciated. |
|
| Author: | Ja-Moo [ Sat May 05, 2018 9:17 am ] |
| Post subject: | Re: Rear Shock specifications |
Building a special it looks like? |
|
| Author: | DGA [ Sat May 05, 2018 11:21 am ] |
| Post subject: | Re: Rear Shock specifications |
My H2B has a 48/ 52 percent front/ rear weight bias. I have lowered the front about 1.5" but still would be a long way off 40/60 I bet. H2B and H2C have the same longer swing arm. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|