Kawi2strokes.com Forum
http://kawi2strokes.com/forum/

Jetting a highly ported H2
http://kawi2strokes.com/forum/viewtopic.php?f=16&t=13052
Page 2 of 2

Author:  motometal [ Sat Dec 02, 2017 11:54 am ]
Post subject:  Re: Jetting a highly ported H2

Assuming the pistons are cut...you could always try a new set which aren't...or which are cut less. Expensive though. This is where some of the reversion and jetting issues come into play, but the cut intake skirt helps top end.

Author:  67lotus49 [ Sun Dec 10, 2017 4:11 pm ]
Post subject:  Re: Jetting a highly ported H2

I sold my 72 a few weeks ago and guessed on jetting that would work at a lower elevation for the new owner in Florida. The bike arrived there
last Friday and he took it right to a shop for jetting and dyno tuning. Jetting as I had it was pretty close already and it pulled 80hp on the
dyno. Made me feel good that the new owner is happy with the bike.

Author:  Jim [ Sun Dec 10, 2017 5:37 pm ]
Post subject:  Re: Jetting a highly ported H2

With all the good work you did getting that bike in shape, I'm sure he's going to be happy with it.

Page 2 of 2 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/