Kawi2strokes.com Forum http://kawi2strokes.com/forum/ |
|
Source for H2 engine bolts http://kawi2strokes.com/forum/viewtopic.php?f=14&t=5645 |
Page 1 of 1 |
Author: | BarryB [ Mon Feb 18, 2013 10:48 am ] |
Post subject: | Source for H2 engine bolts |
Tried the usual suspects, Granger, McMasters and general internet search for suppliers. I found a few sites that have the length and size but all are bulk suppliers, I'm particularly interested in the longer ones - most are close like the 274mm I found in 280mm. Can anyone recommend a supplier? 18 92091-020 BOLT ENGINE MOUNTING 10x274 3 19 92091-021 BOLT ENGINE MOUNTING 8x270 1 20 110B0845 BOLT hex head 8x45 2 21 113B10125 BOLT hex head 10x125 2 |
Author: | Zambia [ Mon Feb 18, 2013 12:30 pm ] |
Post subject: | Re: Source for H2 engine bolts |
http://www.kawasakitripleparts.com/inde ... uct_id=326 |
Author: | mraxl [ Mon Feb 18, 2013 12:55 pm ] |
Post subject: | Re: Source for H2 engine bolts |
Barry, I bought threaded drill rod from Lowes/Home Depot and cut it to length. |
Author: | III [ Mon Feb 18, 2013 12:57 pm ] |
Post subject: | Re: Source for H2 engine bolts |
I am pretty sure Fastenal may be able to provide bolts too Barry. |
Author: | BarryB [ Mon Feb 18, 2013 2:31 pm ] |
Post subject: | Re: Source for H2 engine bolts |
Thanks Ian, bit pricey but there's a reason I like them, shipping and a few extra ones might kill it - but I'll check further. Read on about threads - why I like the OEM/repop ones. Dale, I've done the thread-all before. Problem is any little bit of play in the frame and the threads wear/oblong the mounts more than a solid bolt would (with threads only at the very end). Steve, there's a fastenall in town I hit up last summer - they said nothing like I needed - but I just checked their web site and they have something close enough~! Dale/Steve, one thing I might do is weld/fill the threaded portion where it would be in the mount holes - and then cut them smooth with a lathe. Problem is I don't have a lathe. Solution is I will buy a lathe |
Author: | Ja-Moo [ Mon Feb 18, 2013 3:28 pm ] |
Post subject: | Re: Source for H2 engine bolts |
There should be a sleeve the right size. Just put in a center piece, and you are good to go. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |