| Kawi2strokes.com Forum http://kawi2strokes.com/forum/ |
|
| H1 Pistons http://kawi2strokes.com/forum/viewtopic.php?f=14&t=14936 |
Page 1 of 1 |
| Author: | 0120raptor [ Sun Nov 05, 2023 11:01 am ] |
| Post subject: | H1 Pistons |
Need a rebore and pistons. Which is the best make of piston. |
|
| Author: | Jim [ Sun Nov 05, 2023 12:58 pm ] |
| Post subject: | Re: H1 Pistons |
I believe it's Wössner. |
|
| Author: | ALTERED IMAGE [ Sun Nov 05, 2023 2:49 pm ] |
| Post subject: | Re: H1 Pistons |
Tight forged. New one I have measure within 10ths of advertised. Have not run them yet at .0025" all 3! Wossner cliff |
|
| Author: | Jim [ Sun Nov 05, 2023 4:13 pm ] |
| Post subject: | Re: H1 Pistons |
ALTERED IMAGE wrote: Tight forged. New one I have measure within 10ths of advertised. Last time I had my H2 cylinders bored I measured the Wössners. My Mic's vernier read the same thing for all three. They were so close to each other I took only one piston to the machine shop. I wanted to mill the slots in the skirts of the other two for the reeds while he was working on the cylinders. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|