Kawi2strokes.com Forum
http://kawi2strokes.com/forum/

throttle cable routing
http://kawi2strokes.com/forum/viewtopic.php?f=14&t=13460
Page 1 of 1

Author:  H-nube [ Thu Jun 21, 2018 3:55 pm ]
Post subject:  throttle cable routing

Ok, sorry another question but something again does not seem right. H2, café clip on bars, motion pro new cable, new vm34 carbs. This is what I am working with. I have routed the cable under the headlamp in front of the triple clamps then back along the left side of the upper tube. I thought everything was pretty obvious but it doesn't seem to be so. Three different lengths on the splitter so where does the short one and the medium one go? Does the left one go outside the frame rail? I am thinking the short one goes into the center carb and the medium goes on the left and the long goes far right. I have rerouted everything about 4 times now and it is getting old taking it all back apart. I don't have any binding but something just doesn't seem right. Both my manuals have no original cable mounting guide and I got tired of trying to hunt it down on the resource center. The café bars also don't help.

Author:  Ja-Moo [ Fri Jun 22, 2018 1:17 am ]
Post subject:  Re: throttle cable routing

short always middle carb, main throttle cable on left of frame center, long cable on the right carb and vise versa.

Author:  H-nube [ Fri Jun 22, 2018 9:40 am ]
Post subject:  Re: throttle cable routing

Thanks.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/