III wrote:
If you dont plan to replace them, and they are tight enough to use, why not clean them up while still in the arm Jack?
Why not just flush it out and fill it full of grease?
Personally, I would replace them with either a 20 dollar set from ebay
Or you can get needle roller sleeves they sell. Not sure who has them???
http://www.ebay.com/itm/252326926152?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT I'd like to just clean the bushings out, there tight enough (as in stuck solid) however they are stuck so maybe rust is holding them in, also they won't pass grease , the fitting is clean and will pass grease but where the fitting threads into the swingarm it's a dead end, just a solid steel dead end , maybe the backside of a bushing
Ultimately I need a better set up in my press to hold the swingarm while I push out the old bushing , when I do get them out if they're not damage I will reinstall them, if they're damaged I will get some bronze bushings .