| Kawi2strokes.com Forum http://kawi2strokes.com/forum/ |
|
| 1973 H1D Ignition Coils http://kawi2strokes.com/forum/viewtopic.php?f=14&t=11674 |
Page 1 of 1 |
| Author: | Analogtriple [ Sun Apr 24, 2016 5:15 pm ] |
| Post subject: | 1973 H1D Ignition Coils |
Looking to purchase new (not NOS) coils for the H1D triple. I read the thread about dremel out and solder in new wires. Not sure if I want to do the 4 hour surgery. So - if someone could please point me in the direction of simple replacement coils (that are a certain fit/operation) I'd greatly appreciate it. After all the improvements - I'll probably not want to sell the bike. Thanks in advance! |
|
| Author: | Jim [ Sun Apr 24, 2016 5:42 pm ] |
| Post subject: | Re: 1973 H1D Ignition Coils |
If you need H1D coils, you can get a set of three reproductions for not much over $100 from guys like Jessbikes and Mid Atlantic Cycle. |
|
| Author: | Ja-Moo [ Sun Apr 24, 2016 8:27 pm ] |
| Post subject: | Re: 1973 H1D Ignition Coils |
Or......... https://www.youtube.com/watch?v=jz3pklBtK9o |
|
| Author: | Analogtriple [ Sun Apr 24, 2016 10:37 pm ] |
| Post subject: | Re: 1973 H1D Ignition Coils |
Hey Jim - I did see that Jess repro kit (that says H1D at the end of the description) but I just wanted to get confirmation from end users like yourself - so thanks. Ja-moo your video is excellent - I will go that route first - all I really wanted was new wires to begin with. |
|
| Author: | Ja-Moo [ Mon Apr 25, 2016 10:48 am ] |
| Post subject: | Re: 1973 H1D Ignition Coils |
Glad to help, a cheap fix if the coils are still good. I did find doing a couple of raps of electrical tape under the shrink wrap really seals things up. |
|
| Author: | Jim [ Mon Apr 25, 2016 10:58 am ] |
| Post subject: | Re: 1973 H1D Ignition Coils |
Analogtriple wrote: Hey Jim - I did see that Jess repro kit (that says H1D at the end of the description) but I just wanted to get confirmation from end users like yourself - so thanks. Ja-moo your video is excellent - I will go that route first - all I really wanted was new wires to begin with. I ran a coil test a few years ago, with a motorized H2 alternator and H2 CDI set. The black reproduction coils performed approximately like originals, which are very good. I can't tell you much about coil life, other than I haven't read any posts about failures. |
|
| Author: | Analogtriple [ Sat Apr 30, 2016 8:40 pm ] |
| Post subject: | Re: 1973 H1D Ignition Coils |
Ok guys - I spent the afternoon installing these - https://www.z1enterprises.com/product/DYDW200 Roll throttle = front wheel in the air!!!  Next up - paint the chambers. What a great crowd in this forum - imagine if everyone lived the Triple life - the world would be Smokin!!! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|