| Kawi2strokes.com Forum http://kawi2strokes.com/forum/ |
|
| Rolling H2 with a motor after 20 years of slacking http://kawi2strokes.com/forum/viewtopic.php?f=13&t=14490 |
Page 1 of 1 |
| Author: | h2smokin [ Sun Jun 06, 2021 3:31 pm ] |
| Post subject: | Rolling H2 with a motor after 20 years of slacking |
Motor is built and I installed today finally. Still have to put the clutch in and button up the right side of motor. Installed gauges and carbon fiber housings. Ordering my new coils and going to get a new set of boxes from Jim. Then I hope to have the electrical all hooked up within a few weeks after that. At this point hoping to have running by the end of summer. I still have parts I want to replace but determined to get this running for now. I have all the bodywork painted and waiting once finished |
|
| Author: | Zambia [ Sun Jun 06, 2021 5:23 pm ] |
| Post subject: | Re: Rolling H2 with a motor after 20 years of slacking |
That looks great -no time limit if you're doing it that nice! |
|
| Author: | Tim Steele [ Mon Jun 07, 2021 12:03 am ] |
| Post subject: | Re: Rolling H2 with a motor after 20 years of slacking |
Looks great!!! What flat slides are those? I ask because I am considering putting flat slides on my H2. |
|
| Author: | h2smokin [ Sat Jun 12, 2021 7:28 am ] |
| Post subject: | Re: Rolling H2 with a motor after 20 years of slacking |
They are lectrons. I think I went with 36mm this time. A previous bike I had was using 40mm carbs. Never had an issue with them but thought it was overkill so went a little smaller after talking with a few folks. I have to extend the intake rubber on the center carb. The bowl is hitting the neutral switch so I have to set it back just a bit further |
|
| Author: | Stev-o [ Thu Jul 08, 2021 11:42 am ] |
| Post subject: | Re: Rolling H2 with a motor after 20 years of slacking |
Looks sweet, nice job! Was curious about the flat slides as well. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|