Kawi2strokes.com Forum http://kawi2strokes.com/forum/
caliper piston http://kawi2strokes.com/forum/viewtopic.php?f=13&t=10588	Page 1 of 1

---

Author:	LIRUSS [ Mon Jun 08, 2015 7:06 pm ]
Post subject:	caliper piston
i recently bought 3 brake caliper pistons from 2 different sources & brands & all 3 are a little taller then the original stock pistons, will this be a problem if i use them ? ( i need 2 more)

---

Author:	mraxl [ Mon Jun 08, 2015 7:15 pm ]
Post subject:	Re: caliper piston
I don't think it will be a problem.... but that is guesswork. I believe they are Z1 pistons.

---

Author:	LIRUSS [ Mon Jun 08, 2015 7:25 pm ]
Post subject:	Re: caliper piston
i think you are right but they are advertised as h1 or s3 ...thanks

---

Author:	Retro 3 [ Mon Jun 08, 2015 7:31 pm ]
Post subject:	Re: caliper piston
the ones that I bought, were 1mm taller than stock. if you use new pads and use the shims; they are tight. I cut 1mm from mine.

---

Author:	mraxl [ Mon Jun 08, 2015 7:34 pm ]
Post subject:	Re: caliper piston
Don't always believe what aftermarket vendors say are correct applications.... I guess you already found that out. The KH are the same as Z1.

---

Author:	LIRUSS [ Tue Jun 09, 2015 11:55 pm ]
Post subject:	Re: caliper piston
they are 1.2mm taller , if i remove the alum ring spacer from behind the pad with the screw they work better....what purpose does that ring serve ???

---

Author:	mraxl [ Wed Jun 10, 2015 5:30 am ]
Post subject:	Re: caliper piston
Is this what you refer to? http://3cyl.com/mraxl/partid/list2/43076-001.jpg If so, that is to reduce/eliminate brake squeal.

---

Author:	warehouse1001 [ Wed Jun 10, 2015 9:34 pm ]
Post subject:	Re: caliper piston
X

---

Author:	rusty34 [ Sat Jul 25, 2015 4:54 pm ]
Post subject:	Re: caliper piston
HVC caliper pistons are good. There is a variation among vendors for the height dimension on replacement aftermarket pistons.

---

Page 1 of 1	All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/