Kawi2strokes.com Forum http://kawi2strokes.com/forum/ |
|
electrical issue after valve adjustment http://kawi2strokes.com/forum/viewtopic.php?f=11&t=13813 |
Page 1 of 1 |
Author: | two-stroke-brit [ Thu May 23, 2019 8:23 am ] |
Post subject: | electrical issue after valve adjustment |
Hi All. i have a 89 FZR1000 that i was doing the valve clearances on And thought i would see if it would start before putting everything back on. and i put the battery on charge ,it shows 13.5 volts across the terminals. but absolutely nothing when i turn the key. no lights not even a glimmer. checked the fusses all good there. so jumped from the car and bingo. started right up. but when i check across the battery terminals at idle it shows 16 volt . this is on the bad battery, still waiting on the new one. is it charging to much because the battery if banned word or does this point to a regulator issue. obviously electrix are not my forte. any help is appreciated. mark _____ |
Author: | DGA [ Thu May 23, 2019 11:23 am ] |
Post subject: | Re: electrical issue after valve adjustment |
My KZ1100 did exactly that late last year. Showed good voltage when not under load. They need a load test, not just a simple voltage test, but likely it's time for a new battery. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |